Torch Power Cable: 6AWG Single Insulation. Whoever mfd that piece of ****, and whatever vendors sell it, should be SUED for gross misrepresentation.ĭont buy this **** product, and anyone desperate enough to consider ANY sort of "repair", is (yeah I'll be callously honest here) STUPID!!ĭo not try to stick anything together that anybody needs to count on and far as functionality or ESPECIALLY SAFETY, buy some HUBBA BUBBA, and use that to stick your matrerial together, I doubt it would be any worse. Harbor Freight Tools 90 Amp AC, 120 Volt, Flux Cored Welder Mig & Flux Welder Product Manual CHICAGO ELECTRIC Item 64057-UPC 792363640572 80 Amp Inverter Arc Welder Owners Manual Vulcan 63797 0.025 - 0.045 in. Rated AC Input: 120VAC Single phase power 60Hz, 18 Amps (for use on a 20 Amps Branch circuit) Perfect for up to 1/8 think mild steel. In the end, I finished my little project up with my Duramax's alternators, jumper cables and a COAT HANGER!!īetter looking and better quality beads, decent penetration, smacked the piece pretty good a couple times with the shop hammer, and all held up. I grabbed the leads, dragged the thing over to the door (still plugged in and running), and threw the thing outside into the pouring rain.Īfter resetting my breaker, I called the unfortunate owner, explained my past 2 hours to him, told him Id replace it with a Hobart 110 (still, a hobby welder at best), I held out in front of myself about chest high, and twisted the last weld apart. I then placed the center of it on my thigh, one hand on either side, and pushed - two more beads popped loose. Apply for a Home Depot Consumer Card 18-gauge or 3/16 in. I got 1" of poor quality bead, hit the duty cycle, i could tell, because it wouldnt even feed correctly after that inch.ġ 1/2 hours later, what with letting this toy wanna be cool after every 1 inch worth of bead, I grabbed my work piece, tapped it on my table, and one bead let loose. 90-Amp Flux Welder 155 (21) Questions & Answers (16) +3 Hover Image to Zoom 145 05 Pay 120.05 after 25 OFF your total qualifying purchase upon opening a new card. I borrowed this **** wanna be welder from a buddy today, was in a bind and neaded 4 beads, each 2.5" long.Īfter working out the amps and speed (both ended up maxed out)adjusting the drive roller, I struck my arc on my 20 guage material. I've welded for over 20 years, using countless brands of varying quality, Why would anyone want to repair this thing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |